Remade larger version of one of the parts of the firewall brake mount using a thinner material. After fitting, made the center spacer. Clamped all the parts together and drilled. Trimmed all the edges to match. Installed the completed bracket. Considered different options for the brake line mount on the center rudder bar support. Mocked up several potential mounts with pasteboard. Discussed the two options for location of the firewall feedthrough for GEA 24 signals with Ellicia. Looked at pictures from a project that Deene was supporting. Decided to use a third location that offers several benefits including more room to route wires, lower overall wire length and more clearance above the battery to allow easier replacement.